Tim McGuffin
@tim.mcguff.in
@NotMedic from that other place.
Adversarial Cartographer. DEFCON Staff & CFP Board. MS in DF. Fmr Fire/EMS. Red and Blue. Builder. Tinkerer. Chaotic Good.
Adversarial Cartographer. DEFCON Staff & CFP Board. MS in DF. Fmr Fire/EMS. Red and Blue. Builder. Tinkerer. Chaotic Good.
Sitting at a campsite in the middle of nowhere when Benny Bassani’s “Satisfaction” starts playing far off in distance, and I’m suddenly transported back to Capture the Flag at the AP in 2002-2003. Some memories are deeply ingrained.
March 10, 2025 at 2:07 PM
Sitting at a campsite in the middle of nowhere when Benny Bassani’s “Satisfaction” starts playing far off in distance, and I’m suddenly transported back to Capture the Flag at the AP in 2002-2003. Some memories are deeply ingrained.
Reminder that every 10 minute job is one broken bolt away from being an all day ordeal. :-/
March 1, 2025 at 4:04 PM
Reminder that every 10 minute job is one broken bolt away from being an all day ordeal. :-/
This is a picture some of y’all can smell.
February 23, 2025 at 8:23 PM
This is a picture some of y’all can smell.
i picked up a GLEDOPTO WLED controller because it fit my hardware needs and figured out how to re-flash it with a different firmware. Maybe this will be useful to others who have a similar need.
tim.mcguff.in/posts/2025-0...
tim.mcguff.in/posts/2025-0...
Flash GLEDOPTO GL-C-210WL
I was recently working on a project that needed an ESP32 powered from a 12 volt source with 4 GPIO PINs, ready-made, and in a case. I started going down the custom built route when I ran across the GL...
tim.mcguff.in
February 20, 2025 at 2:18 PM
i picked up a GLEDOPTO WLED controller because it fit my hardware needs and figured out how to re-flash it with a different firmware. Maybe this will be useful to others who have a similar need.
tim.mcguff.in/posts/2025-0...
tim.mcguff.in/posts/2025-0...
I should probably add some content here. :)
Recently I’ve been working on building an RC quadruped robot. This is v2, with a lot of learnings from v1. Physically it’s a SMARS Quad running an ESP32, PCA9685, and FS-IA6B receiver running Micropython.
Recently I’ve been working on building an RC quadruped robot. This is v2, with a lot of learnings from v1. Physically it’s a SMARS Quad running an ESP32, PCA9685, and FS-IA6B receiver running Micropython.
July 11, 2023 at 2:24 AM
I should probably add some content here. :)
Recently I’ve been working on building an RC quadruped robot. This is v2, with a lot of learnings from v1. Physically it’s a SMARS Quad running an ESP32, PCA9685, and FS-IA6B receiver running Micropython.
Recently I’ve been working on building an RC quadruped robot. This is v2, with a lot of learnings from v1. Physically it’s a SMARS Quad running an ESP32, PCA9685, and FS-IA6B receiver running Micropython.