Yup, the Naboo Starfighter from Willi on Printables. The other part was the base of the Wolverine Claw from Hex3D... Still need to clean it up, Gloop it together and then figure out how to paint it.

The last of the silver finished overnight. Not sure how, but it looks like they are nearly solid, which explains the 1.5 day print time.

I have to slice the red parts, then double check I printed everything. Looks like the Gloop is a few days out, but hopefully I can assemble it this week.

The second plate of silver is done, the first was just the fins, the third plate is going now, and almost done. Then on to the big day and a half of printing plate.

I printed the tall black parts last night, now I am on to the silver parts. Looks to be about 2.5 days of printing.

It's been a while, took a break, but back to printing the Fab365 Saturn V rocket. Here is where it is now, I have some black parts going now, I also have some Gloop coming to start gluing it together.

First plate of Black parts finished yesterday, starting another this morning.

Forgot to post last night, but the fourth (I think) white plate finished with some smaller parts, and the fifth finished this morning. Now on to the Black parts.

I may do one of the other models much bigger, just for fun, but I would need a whole lot more filament to go that big for this one. I am also half way done :(

Also a picture of all three completed sections, sitting on one of my 350mm Voron 2.4's for scale. Honest, I wish I had just gone for it and maxed out the SV-06 plate, it would have been nearly 5.5ft tall 😍

And, the third big section is done. I started this one yesterday and actually forgot to check on it before bed last night, so I was very happy to see it had no issues. Some smaller white pieces to go, then on to the black parts.

Just realized I never posted the finished print for the first one...

Second part is finished, now on to part three.

First part came out great, just over a day of printing. I am tempted by the SV-08, but I don't do a lot of PLA, and my Voron's handle all my ABS/ASA needs.

Looking good so far, 1/5th of the way through this part.🤞