MOT prep in full swing. Handbrake now handbrakes.

And here it is installed in the Defender. It was a tight fit, but it’s definitely usable.

The original clip for the mount was threaded on to a ball to allow for tilting and rotating. Making a sphere in shapr3d wasn’t super obvious, but I landed on this version.

My initial plan was to make a base that would fill the void and a little fork to grab the existing mount.

The ashtray on my Defender had become loose. I tried tightening the clips up when I last had the dash off, but it still wasn’t a stable base for my clip on phone charger.