Made with Layers
madewithlayers.bsky.social
Made with Layers
@madewithlayers.bsky.social
In case you're wondering why I haven't covered the Prusa Core One L yet: Well, I was planning to go to the launch, but Covid finally got me after all this time. Those were two horrible weeks of my life that I'll never get back, and I'm still not back to 100% on stamina and smell.
November 4, 2025 at 7:11 PM
BLDC servos are smaller and more powerful than steppers - then why aren't we using them everywhere?
Why Are 3D Printers Still Using ANCIENT Motors?
..and why is the answer "it depends"? 😁 Thanks to #UGREEN for sponsoring a part of this video! Check out the #UGREENNAS DXP4800 Plus and their Prime Day collection direct from UGREEN (US)…
www.youtube.com
October 7, 2025 at 10:00 PM
Yes, I'm still alive (and the cake was fantastic)!
Meet Caroline, my experimental low-cost robot arm - swinging a camera today, on the way to running my Studio tomorrow.
www.youtube.com/watch?v=rKyJ...
Meet Caroline: Testing ways to build a cheap Robot Arm (for science!)
I loved building Caroline, hope it shows in the video! Thanks to VoxelPLA for sponsoring this project! Check out their filaments and accessories at https://voxelpla.com/madewithlayers CNC Kitchen…
www.youtube.com
August 13, 2025 at 9:00 PM
If you're at Open Sauce tomorrow, do check out Caroline - she'll be hanging out in the far corner of the Creator Museum, ready to give you some side-eye 😉

(Creator Museum is to the right as you walk into the main stage building)
July 20, 2025 at 2:51 AM
If you're at Open Sauce tomorrow, do check out Caroline - she'll be hanging out in the far corner of the Creator Museum, ready to give you some side-eye 😉

(Creator Museum is to the right as you walk into the main stage building)
July 20, 2025 at 2:51 AM
Found some lovely people at Open Sauce that could give my little robot project a ride to the creator museum 🤩
July 19, 2025 at 3:45 PM
Ready for packaging (minus a few details)
Let's hope she survives the flight!
July 11, 2025 at 3:30 PM
Basically, a modern-day Ender-3
youtu.be/xjQzALNuwCM
Could this be the new 4-color Ender-3? Anycubic Kobra 3 v2 (Combo)
YouTube video by Made with Layers (Thomas Sanladerer)
youtu.be
July 11, 2025 at 11:34 AM
I'm building a little something to bring to OpenSauce 🍰
July 2, 2025 at 7:15 PM
Handle secured.
September 7, 2023 at 9:56 AM