Leo
@leowhite.bsky.social
I'm a software engineer of many years who's spent the past few trying to work out how to squeeze Raspberry Pis into a variety of toys..
One blade setup, with fan, and the case being printed (12 hour print job!)
October 19, 2025 at 5:52 PM
One blade setup, with fan, and the case being printed (12 hour print job!)
Downside is its very, very noisy.
August 13, 2025 at 11:05 AM
Downside is its very, very noisy.
Everything re-installed into a newly 3D printed case (makerworld.com/en/models/16...)
Has a bit more room inside than the last one, plus has 4 3.5" bays.
just need to work out where I put my fan controller, as its rather noisy at 100% speed.
Has a bit more room inside than the last one, plus has 4 3.5" bays.
just need to work out where I put my fan controller, as its rather noisy at 100% speed.
July 27, 2025 at 3:27 PM
Everything re-installed into a newly 3D printed case (makerworld.com/en/models/16...)
Has a bit more room inside than the last one, plus has 4 3.5" bays.
just need to work out where I put my fan controller, as its rather noisy at 100% speed.
Has a bit more room inside than the last one, plus has 4 3.5" bays.
just need to work out where I put my fan controller, as its rather noisy at 100% speed.
If only I had read this before going to the shops at lunch time, I could have stocked up!
February 5, 2025 at 3:54 PM
If only I had read this before going to the shops at lunch time, I could have stocked up!
They also start with telling you the movie contains minimal interruptions.
I'd find it less annoying if they just straight up said 'This movie contains ads'.
I'd find it less annoying if they just straight up said 'This movie contains ads'.
December 3, 2024 at 11:07 PM
They also start with telling you the movie contains minimal interruptions.
I'd find it less annoying if they just straight up said 'This movie contains ads'.
I'd find it less annoying if they just straight up said 'This movie contains ads'.
Thanks!
Magneto did do a bit of high diving on the first attempt, before I worked out the drone was just trying to go higher and higher!
Magneto did do a bit of high diving on the first attempt, before I worked out the drone was just trying to go higher and higher!
November 30, 2024 at 2:23 PM
Thanks!
Magneto did do a bit of high diving on the first attempt, before I worked out the drone was just trying to go higher and higher!
Magneto did do a bit of high diving on the first attempt, before I worked out the drone was just trying to go higher and higher!
November 30, 2024 at 1:57 PM
November 29, 2024 at 5:03 PM
I've barely touched the Yukon I got when it was first released :(
November 28, 2024 at 10:32 AM
I've barely touched the Yukon I got when it was first released :(