Star Trail is up and printing in its own enclosure. Active chamber heater and internal spools so they can sit in the heat to help chase away the moisture. Just a little bit more tuning needed but it's been good so far from the test I've done.

Time to get spicier filaments >:3

When you forget to make sure there's enough adhesive on the plate to hold down the print.

Better luck next print lmao

and there we go, its first print. the humble voron cube :3

Did I ever mention I finally got this printer powered on and running on its own power? Once I get a spool holder printed I'll probably run a test print tomorrow to make sure everything is configured right before I work on the panels.